Measurement Systems - forefront of the data acquisition market
Username: Password: Register       Buy Online  
Products
I-7243D Modbus TCP server to DeviceNet Master Gateway  £210.00 

The i-7243D from ICP DAS is a solution that provides a communication protocol transfer the DeviceNet and Modbus/TCP protocol and solves a mission-critical problem: connecting an existing DeviceNet network to Ethernet-base PLCs and PC-based configuration and monitor system. It enables DeviceNet networks to be coupled together over the Internet/Ethernet, whereby remote monitoring and control is possible.

The i-7243D can be a DeviceNet master device in the CAN bus on the DeviceNet network. It is a “Predefined Master connection Set”, and supports Group 2 only Server functions to communication with slave devices. In addition, we also provide Utility software for users to configure their device parameters for the i-7243D. The following figure shows the application architecture for the i-7243D.

I-7243D ModbusTCP-DeviceNet

Quantity:     

Features

  • Programmable DeviceNet Master MAC ID.
  • Programmable DeviceNet transfer-rate 125K, 250K, 500K.
  • Supports maximum DeviceNet devices up to 63
  • Predefined Master/Slave Connection Set
  • The maximum Fragment number is (Input/Output) up to 64
  • Supports I/O Operation Mode: Poll, Bit-Strobe and Change Of State/Cyclic
  • Supports one Poll, one Bit-Strobe, one COS, one Cyclic IO connection for each DeviceNet device when
  • connected with this module.
  • Supports on-line adding device into and removing device from network.
  • Supports boot-up auto communicate with slave devices.
  • Converters single Mobbus/TCP to multi Modbus/RTU, setting by Utility
  • Supports VxComm technique for every COM ports of controllers, setting by Utility
  • Allowed multi-client (or master) access simultaneously

    • Specifications

  • CPU : 80186-80MHz 
  • Flash : 512K bytes
  • SRAM : 512K bytes
  • EEPROM : 16K bytes 
  • Ethernet Port : 10/100Base-TX Ethernet Controller 
    (Auto-negotiating, Auto-MDIX, LED Indicator)
  • Real Time Clock (RTC) : Yes
  • CAN Signal Support : CAN_H, CAN_L
  • CAN Connector : 5-pin screw terminal connector
  • Power Consumption : 3W
  • COM1 : RS232 (TxD, RxD, RTS, CTS, GND)
  • COM2 : RS485 (D2+, D2-)
  • Communication Speed : 115.2k
  • CAN Controller : Philips SJA1000T CAN Controller
  • CAN Transceiver : Philips 82C250/251 CAN Transceiver
  • LED Directors : MS, NS, RUN
  • Display : 7 segment LED, 5 digit
  • Isolation : 1kVdc on CAN side
  • Power Supply : +10Vdc to +30Vdc
  • Operating Temperature : -25C to +75C
  • Storage Temperature : -40C to +85C
  • Humidity : 5-95%
  • Dimensions : 123 x 72 x 33 mm
    		•

    Technical

    Quickstart Guide
    User Manual

    Applications

  • Control System
  • Building Automation
  • Factory Automation
  • Distributed data acquisition
  • Home Automation
  • Monitoring System
    		•

    Recommendations

    Power Supplies
    Terms of Use | Privacy Policy | Resources | How to Order | Site Map