EA110 Bridge Amplifier for Full and Half Bridge sensors Measurement Systems

EA110 Bridge Amplifier for Full and Half Bridge sensors

£380.00

The EA110 is a software controlled high-sensitivity amplifier for use with un-powered or powered transducers requiring full or half DC bridge circuitry. It uses chopper stabilized amplifier techniques to reduce temperature drift an doffers software controlled zeroing.

This amplifier is ideally suited to operate with bridge type transducers used to monitor force pressure and related quantities. Filter settings and offset capability are optimized for the measurement of physical parameters.

EA110 Bridge Amplifier for Full and Half Bridge sensors

Quantity:

Features

Transducer connection is via an 8-pin DIN Connector.

Software controlled gain offset and filter settings

Plug and Play installation with e-corder units

May be used with unpowered or powered transducers

Used with Full or Half DC bridge circuitry

Programming resistors in transducer plug automatically set excitation and offset range.

Specifications

Input : 1 differential(8-pin DIN)

Amplification Range: +/-50uV to +/-200mV full scale in 12 steps.

Amplification Accuracy: +/-0.5%

Max.Input Voltage: +/-5V

Input Impedance: 2kohm

Excitation Voltage range : 0-20Vdc (+/-10V referred to GND)

For full specifications please refer to the datasheet.

Technical

E-corder Brochure
E-corder Product Guide
EA110 Datasheet

Applications

Ideally suited to operate bridge type transducers to monitor Force, Pressure and related quantities.