PIO-D48 48-channel OPTO-22 Digital IO Board

• Description
• Features
• Specifications
• Technical

The PIO-D48 provides 48 TTL digital I/O lines, consisting of six 8-bit bi-direction ports. The 8-bit ports are named port A (PA), port B (PB), port C (PC) with all ports being configured as inputs upon power-up or reset.

The PIO-D48 has one D-Sub connector and one 50-pin flat cable connectors. Each header can connect to a 50-pin flat cable, which in turn can be connected to an ADP-37/PCI or ADP-50/PCI adapter. The adapter can then be fixed on the chassis. 

This card can be installed in a 32-bit 5 V PCI bus and can support "Plug & Play".

NOW Universal PCI so can be installed in 3.3V or 5V bus PCI slots.  

• 32-bit +5V PC compatible PCI bus, Plug and Play
• Double side SMT, short card, power saving
• All I/O lines buffered on the board
• 48 channel digital TTL/DTL I/O Lines
• Emulate 7/6/4 Industrial standard 8255 PPI mode 0
• Programmable direct-trigger interrupt source
• High output driving capability
• Output status readback
• DIO response time is about 0.77 us (1.3 MHz max.)
• Direct Interface with OPTO-22 compatible I/O Modules

Software

• One DB-37 connector and one 50-pin flat-cable connectors
• Input Logic high voltage : 2.4V min.
• Input Logic low voltage : 0.8V max.
• Output Sink Current : 64mA max.
• Output Source Current : 32mA max.
• Each connector consists of three 8-bit port, PA, PB & PC in every connector
• Each port can be programmed as D/I or D/O independently
• Each board = 2 connector = 2*3 port = 2*3*8 bit =48 bit
• Programmable interrupt sources : P2C3, P2C7, P5C3, P5C7
• All signals are TTL compatible
• Power Requirements : +5V@500mA
• Operating temperature : 0~60°C
• Storage temperature : -20~70°C
• Humidity : 0~90% RH, non-condensing
• Dimensions : 156mm x 105mm

Dig I/O Shortform Catalogue